The top, back and ribs of an acoustic guitar body are very thin (1–2 mm), so a flexible piece of wood called lining is glued into the corners where the rib meets the top and back. This interior reinforcement provides 5 to 20 mm of solid gluing area for these corner joints. Solid linings are often used in classical guitars, while kerfed lining is most often found in steel string acoustics. Kerfed lining is also called kerfing because it is scored, or "kerfed"(incompletely sawn through), to allow it to bend with the shape of the rib). During final construction, a small section of the outside corners is carved or routed out and filled with binding material on the outside corners and decorative strips of material next to the binding, which are called purfling. This binding serves to seal off the end grain of the top and back. Purfling can also appear on the back of an acoustic guitar, marking the edge joints of the two or three sections of the back. Binding and purfling materials are generally made of either wood or plastic.
Body size, shape and style has changed over time. 19th century guitars, now known as salon guitars, were smaller than modern instruments. Differing patterns of internal bracing have been used over time by luthiers. Torres, Hauser, Ramirez, Fleta, and C. F. Martin were among the most influential designers of their time. Bracing not only strengthens the top against potential collapse due to the stress exerted by the tensioned strings, but also affects the resonance characteristics of the top. The back and sides are made out of a variety of timbers such as mahogany, Indian rosewood and highly regarded Brazilian rosewood (Dalbergia nigra). Each one is primarily chosen for their aesthetic effect and can be decorated with inlays and purfling.
Guitarists don’t have to just look on in envy as pianists lead the holiday sing-a-longs this Christmas. Our selection of holiday Guitar Tabs include traditional classics we all love like “O Holy Night” and “Carol of the Bells” and the pop favorites that just wouldn’t be the same without a guitar, like “Jingle Bell Rock” and “Happy Xmas (War is Over)” by John Lennon. But if you just can’t get enough of those traditional Christmas classics, you can pick up our collection of ’Christmas Favorites for Guitar.’
The types and models of pickups used can greatly affect the tone of the guitar. Typically, humbuckers, which are two magnet-coil assemblies attached to each other, are traditionally associated with a heavier sound. Single-coil pickups, one magnet wrapped in copper wire, are used by guitarists seeking a brighter, twangier sound with greater dynamic range.
For example, in the guitar (like other stringed instruments but unlike the piano), open-string notes are not fretted and so require less hand-motion. Thus chords that contain open notes are more easily played and hence more frequently played in popular music, such as folk music. Many of the most popular tunings—standard tuning, open tunings, and new standard tuning—are rich in the open notes used by popular chords. Open tunings allow major triads to be played by barring one fret with only one finger, using the finger like a capo. On guitars without a zeroth fret (after the nut), the intonation of an open note may differ from then note when fretted on other strings; consequently, on some guitars, the sound of an open note may be inferior to that of a fretted note.
Picks come in many shapes and sizes. Picks vary from the small jazz pick to the large bass pick. The thickness of the pick often determines its use. A thinner pick (between 0.2 and 0.5 mm) is usually used for strumming or rhythm playing, whereas thicker picks (between 0.7 and 1.5+ mm) are usually used for single-note lines or lead playing. The distinctive guitar sound of Billy Gibbons is attributed to using a quarter or peso as a pick. Similarly, Brian May is known to use a sixpence coin as a pick, while noted 1970s and early 1980s session musician David Persons is known for using old credit cards, cut to the correct size, as plectrums.
The musical theory of chords is reviewed, to provide terminology for a discussion of guitar chords. Three kinds of chords, which are emphasized in introductions to guitar-playing, are discussed. These basic chords arise in chord-triples that are conventional in Western music, triples that are called three-chord progressions. After each type of chord is introduced, its role in three-chord progressions is noted.
Conventionally, guitarists double notes in a chord to increase its volume, an important technique for players without amplification; doubling notes and changing the order of notes also changes the timbre of chords. It can make a possible a "chord" which is composed of the all same note on different strings. Many chords can be played with the same notes in more than one place on the fretboard.