The truss rod is a thin, strong metal rod that runs along the inside of the neck. It is used to correct changes to the neck's curvature caused by aging of the neck timbers, changes in humidity, or to compensate for changes in the tension of strings. The tension of the rod and neck assembly is adjusted by a hex nut or an allen-key bolt on the rod, usually located either at the headstock, sometimes under a cover, or just inside the body of the guitar underneath the fretboard and accessible through the sound hole. Some truss rods can only be accessed by removing the neck. The truss rod counteracts the immense amount of tension the strings place on the neck, bringing the neck back to a straighter position. Turning the truss rod clockwise tightens it, counteracting the tension of the strings and straightening the neck or creating a backward bow. Turning the truss rod counter-clockwise loosens it, allowing string tension to act on the neck and creating a forward bow.
Another factor to consider are the alloys used to make the string. Acoustic strings may be phosphor bronze or an 80/20 bronze/zinc alloy, electric strings may be pure steel or a steel/nickel alloy, and the outer winding on the thicker strings may be either round wound or flat wound, which is typically used by jazz guitarists for smooth fingering with less fretting noise. Acoustic and electric strings are both now available with special super-thin coatings to protect them from sweat and corrosion. Coated strings cost more, but generally last much longer. Find out what type of string your favorite player uses, try guitars with different types of strings at your local guitar store, then try a few different sets on your guitar to see what feels and sounds best for your playing style. Major manufacturers include Ernie Ball, Martin, GHS, D'Addario, and Elixir, among others. Make sure you have a string winder to make installing the strings go faster, and some pliers with a fine wire cutter to clip the excess string from the tuning post, a well as some guitar polish - changing strings is a good time to perform some routine maintenance. Keep a clean cloth in your case to wipe down the strings after each use, along with extra bridge pins for your acoustic guitar. Regular string changes are the best way to keep your tone crisp and clear, so grab a pack and tune 'em up!
So with that in mind, would you like to learn the guitar on your own or with others? The choice is yours at Guitar Center. If you prefer one-on-one instruction, that's absolutely doable - in fact, you'll find our schedule to be very flexible. Of course, learning in a group is an excellent way to meet like-minded musicians with similar tastes and share ideas on how to improve one another's craft. Who knows, you might even leave a group guitar lesson with plans to start a band with your newfound musical companions. Either way, our group and private guitar lessons are very entertaining and informative.
A guitar strap is a strip of material with an attachment mechanism on each end, made to hold a guitar via the shoulders at an adjustable length. Guitars have varying accommodations for attaching a strap. The most common are strap buttons, also called strap pins, which are flanged steel posts anchored to the guitar with screws. Two strap buttons come pre-attached to virtually all electric guitars, and many steel-string acoustic guitars. Strap buttons are sometimes replaced with "strap locks", which connect the guitar to the strap more securely.
Paul Gilbert has made Guitar World's "50 Fastest Guitarists of All Time", and his guitar shredding is legendary. Paul picked up his first guitar when he was 5 years old. By the time he was 15, he was featured in Guitar Player magazine. After graduating from the Guitar Institute of Technology (GIT) in Los Angeles, Paul immediately joined the faculty as a guitar teacher. While teaching, he formed the band Racer X and Grammy-nominated group Mr. Big. Paul breaks down his iconic playing techniques and practice drills. He's known for his enthusiastic and approachable guitar lessons, which are founded on decades of experience.
The modern word guitar, and its antecedents, has been applied to a wide variety of chordophones since classical times and as such causes confusion. The English word guitar, the German Gitarre, and the French guitare were all adopted from the Spanish guitarra, which comes from the Andalusian Arabic قيثارة (qīthārah) and the Latin cithara, which in turn came from the Ancient Greek κιθάρα (kithara).[A] which comes from Persian word Sihtar. We can see this kind of naming in Setar, Tar, Dutar and Sitar. The word "Tar" at the end of all of these words is a Persian word that means "string".