A capo (short for capotasto) is used to change the pitch of open strings.[28] Capos are clipped onto the fretboard with the aid of spring tension, or in some models, elastic tension. To raise the guitar's pitch by one semitone, the player would clip the capo onto the fretboard just below the first fret. Its use allows players to play in different keys without having to change the chord formations they use. For example, if a folk guitar player wanted to play a song in the key of B Major, they could put a capo on the second fret of the instrument, and then play the song as if it were in the key of A Major, but with the capo the instrument would make the sounds of B Major. This is because with the capo barring the entire second fret, open chords would all sound two semitones (aka one tone) higher in pitch. For example, if a guitarist played an open A Major chord (a very common open chord), it would sound like a B Major chord. All of the other open chords would be similarly modified in pitch. Because of the ease with which they allow guitar players to change keys, they are sometimes referred to with pejorative names, such as "cheaters" or the "hillbilly crutch". Despite this negative viewpoint, another benefit of the capo is that it enables guitarists to obtain the ringing, resonant sound of the common keys (C, G, A, etc.) in "harder" and less-commonly used keys. Classical performers are known to use them to enable modern instruments to match the pitch of historical instruments such as the Renaissance music lute.
A string’s gauge is how thick it is. As a general rule, the thicker a string is the warmer its response will be and the more volume it will produce. However, thicker strings are also stiffer. This makes it harder to fret the string and makes it more difficult to execute heavy string bends. Thinner strings are generally brighter and easier to play, but on some instruments they can sound thin and tinny.
A guitar strap is a strip of material with an attachment mechanism on each end, made to hold a guitar via the shoulders at an adjustable length. Guitars have varying accommodations for attaching a strap. The most common are strap buttons, also called strap pins, which are flanged steel posts anchored to the guitar with screws. Two strap buttons come pre-attached to virtually all electric guitars, and many steel-string acoustic guitars. Strap buttons are sometimes replaced with "strap locks", which connect the guitar to the strap more securely.
By now, you’ve already decided whether to stick with the Guitar or to drop it. If you’re one of the lucky few that stuck with it, in spite of having an extremely busy schedule with work and family obligations, congratulations. Contrary to popular belief, taking the time out for routine Guitar practice has tremendous benefits, even for the busiest of people.
Ive been playing guitar for about 3 years, and this is the best song book I have ever learned from. Songs range from sweet home alabama by lynard skynard all the way to raining blood by slayer. All of the songs are accurate and complete with notes, tabs, lyrics, and copyright info. If you are like me, and you prefer to learn songs the way they were meant to be played than this book is for you.

A slide, (neck of a bottle, knife blade or round metal or glass bar or cylinder) is used in blues and rock to create a glissando or "Hawaiian" effect. The slide is used to fret notes on the neck, instead of using the fretting hand's fingers. The characteristic use of the slide is to move up to the intended pitch by, as the name implies, sliding up the neck to the desired note. The necks of bottles were often used in blues and country music as improvised slides. Modern slides are constructed of glass, plastic, ceramic, chrome, brass or steel bars or cylinders, depending on the weight and tone desired (and the amount of money a guitarist can spend). An instrument that is played exclusively in this manner (using a metal bar) is called a steel guitar or pedal steel. Slide playing to this day is very popular in blues music and country music. Some slide players use a so-called Dobro guitar. Some performers who have become famous for playing slide are Robert Johnson, Elmore James, Ry Cooder, George Harrison, Bonnie Raitt, Derek Trucks, Warren Haynes, Duane Allman, Muddy Waters, Rory Gallagher, and George Thorogood.
Entire contents Copyright © Musician's Friend Inc. Musician's Friend is a registered trademark of Musician's Friend Inc. All Rights Reserved. Publisher does not accept liability for incorrect spelling, printing errors (including prices), incorrect manufacturer's specifications or changes, or grammatical inaccuracies in any product included in the Musician's Friend catalog or website. Prices subject to change without notice.
Ernie Ball is the world's leading manufacturer of premium electric, acoustic, and classical guitar strings, bass strings, mandolin, banjo, pedal steel strings and guitar accessories. Our strings have been played on many of the best-selling albums of all time and are used by some of history’s greatest musicians including Paul McCartney, Eric Clapton, Jimmy Page, Slash, The Rolling Stones, Angus Young, Eagles, Jeff Beck, Pete Townshend, Aerosmith, Metallica, and more.
YellowBrickCinema’s Sleep Music is the perfect relaxing music to help you go to sleep, and enjoy deep sleep. Our music for sleeping is the best music for stress relief, to reduce insomnia, and encourage dreaming. Our calm music for sleeping uses Delta Waves and soft instrumental music to help you achieve deep relaxation, and fall asleep. Our relaxing sleep music can be used as background music, meditation music, relaxation music, peaceful music and sleep music. Let our soothing music and calming music help you enjoy relaxing deep sleep.
In major-thirds (M3) tuning, the chromatic scale is arranged on three consecutive strings in four consecutive frets.[83][84] This four-fret arrangement facilitates the left-hand technique for classical (Spanish) guitar:[84] For each hand position of four frets, the hand is stationary and the fingers move, each finger being responsible for exactly one fret.[85] Consequently, three hand-positions (covering frets 1–4, 5–8, and 9–12) partition the fingerboard of classical guitar,[86] which has exactly 12 frets.[note 1]
The next step is to figure out what gauge, or thickness of string is best suited to your playing ability and style. Thinner gauges are easier to fret and bend, and may be better suited for beginners, until callouses build up on the fingertips. Heavier strings tend to produce greater volume and fuller tone. Nylon strings are typically categorized as light, medium or heavy tension. Steel strings for both electric and acoustic guitars are categorized by the gauge, or thickness of the lightest string, the high E string, measured in thousandths of an inch, with .09 being a common size for an electric set. A set of electric strings may be labeled .09-.042 - this is the gauge of the lightest and heaviest string in the set. Acoustic sets are a little thicker, so a typical medium-gauge set might be .012-.054.
Learning guitar is a lot easier when you have a step-by-step system to follow. Guitar Tricks lessons are interconnected and organized to get slightly harder as you progress. You watch a video lesson, play along, and then click a “Next” button to go to the next lesson. Lessons have multiple camera angles, guitar tabs, jam tracks and everything else you need to learn.
Our intermediate and advanced guitar lessons are tailored to build on the skills that students have developed through their previous beginner lessons and programs. These programs pair private guitar lessons with full-band group rehearsals and live performances, allowing student guitarists to showcase their skills by playing advanced songs from famous musicians. Our world-class guitar instructors and teaching system are proven to help students play and perform at a higher level.
On almost all modern electric guitars, the bridge has saddles that are adjustable for each string so that intonation stays correct up and down the neck. If the open string is in tune, but sharp or flat when frets are pressed, the bridge saddle position can be adjusted with a screwdriver or hex key to remedy the problem. In general, flat notes are corrected by moving the saddle forward and sharp notes by moving it backwards. On an instrument correctly adjusted for intonation, the actual length of each string from the nut to the bridge saddle is slightly, but measurably longer than the scale length of the instrument. This additional length is called compensation, which flattens all notes a bit to compensate for the sharping of all fretted notes caused by stretching the string during fretting.
A string’s gauge is how thick it is. As a general rule, the thicker a string is the warmer its response will be and the more volume it will produce. However, thicker strings are also stiffer. This makes it harder to fret the string and makes it more difficult to execute heavy string bends. Thinner strings are generally brighter and easier to play, but on some instruments they can sound thin and tinny.
The nut is a small strip of bone, plastic, brass, corian, graphite, stainless steel, or other medium-hard material, at the joint where the headstock meets the fretboard. Its grooves guide the strings onto the fretboard, giving consistent lateral string placement. It is one of the endpoints of the strings' vibrating length. It must be accurately cut, or it can contribute to tuning problems due to string slippage or string buzz. To reduce string friction in the nut, which can adversely affect tuning stability, some guitarists fit a roller nut. Some instruments use a zero fret just in front of the nut. In this case the nut is used only for lateral alignment of the strings, the string height and length being dictated by the zero fret.
Further simplifications occur for the regular tunings that are repetitive, that is, which repeat their strings. For example, the E-G♯-c-e-g♯-c' M3 tuning repeats its octave after every two strings. Such repetition further simplifies the learning of chords and improvisation;[71] This repetition results in two copies of the three open-strings' notes, each in a different octave. Similarly, the B-F-B-F-B-F augmented-fourths tuning repeats itself after one string.[73]
There's no other instrument with as much presence and cultural identity as the guitar. Virtually everyone is familiar with tons of different guitar sounds, from intense metal shredding to soft and jaunty acoustic folk music. And behind all those iconic guitar tones are great sets of strings. Just like a saxophonist changes reeds from time to time or a drummer replaces sticks, putting new strings on your guitar every so often is an important part of owning and playing one.
On a day when there's a temptation to go into a dark place, and only see all the bad stuff there is in the world ... greed, cruelty, exploitation, selfishness ... I get days like that pretty often .... it's great to find someone giving out, and giving out good, and operating on an honour basis ... There are so many people who can't afford Guitar lessons .... well, here's a wonderful guy who has set up a whole system of teaching guitar ... Blues, Jazz, Rock, even Songwriting, from the basics, tuning the guitar, etc ... upwards ... If you use his site, it's up to you to determine how much you can contribute ... but this is an amazing site .... he is also very aware of issues in the world which need attention ... a great channel .. Check him out. He's a giver.
Once you've got your categories narrowed down, then you can start getting into the nitty-gritty differences between strings. For instance, electric guitars will give you the choice between nickel (for authentic vintage sound) and stainless steel (for maximum durability). Some string manufacturers have exotic material options with their own unique characteristics, like Ernie Ball's Slinky Cobalt strings. With so many subtle differences separating guitar strings, you owe it to yourself to browse carefully and look at all the choices on the table before making a decision.

If you’re the type of parent who believes music can improve early childhood development, science has good news for you. A recent study suggests that guitar practice can help children better and faster process music and verbal language. Hearing different pitches and tones can help one better parse spoken words. So while every parent should remain careful not to forcefully involve their little ones in music, sports, and other interests, parents can still take a gentler approach that stimulates joy and curiosity, and plant a seed for lifelong learning.
Justin, first off I just wanted to say thanks for all the advice and instruction. You make playing guitar easy and understandable and fun. You explain very well the hows and whys when presenting a new song to learn and walk it through so that anyone can learn. I have played guitar for 20 years now and have learned more from you in the last five years than the previous 15 by myself. You have also been a tremendous help to both my son and my daughter in learning to play as well by making playing fun and interesting. I have a couple of pictures of me and my children all doing what we love. Many Thanks to you Justin
The top, back and ribs of an acoustic guitar body are very thin (1–2 mm), so a flexible piece of wood called lining is glued into the corners where the rib meets the top and back. This interior reinforcement provides 5 to 20 mm of solid gluing area for these corner joints. Solid linings are often used in classical guitars, while kerfed lining is most often found in steel string acoustics. Kerfed lining is also called kerfing because it is scored, or "kerfed"(incompletely sawn through), to allow it to bend with the shape of the rib). During final construction, a small section of the outside corners is carved or routed out and filled with binding material on the outside corners and decorative strips of material next to the binding, which are called purfling. This binding serves to seal off the end grain of the top and back. Purfling can also appear on the back of an acoustic guitar, marking the edge joints of the two or three sections of the back. Binding and purfling materials are generally made of either wood or plastic.
Unlike a piano or the voices of a choir, the guitar (in standard tuning) has difficulty playing the chords as stacks of thirds, which would require the left hand to span too many frets,[40] particularly for dominant seventh chords, as explained below. If in a particular tuning chords cannot be played in closed position, then they often can be played in open position; similarly, if in a particular tuning chords cannot be played in root position, they can often be played in inverted positions. A chord is inverted when the bass note is not the root note. Additional chords can be generated with drop-2 (or drop-3) voicing, which are discussed for standard tuning's implementation of dominant seventh chords (below).
I strongly recommend beginner guitar players to use the Uberchord app (click for free download) for practicing chord progressions and chord changes, and use the real-time feedback to improve your playing skills. While, I’ll help you expedite the process of grabbing chords confidently on the neck and get you on your way to playing along expertly with your favourite band, or better yet, running a band of your own.

The Master of Music in Performance (Guitar) from Musicians Institute combines advanced performance training with additional study in both traditional and contemporary disciplines such as music history, theory, education, research skills, recording technology, production, business relations and online brand management, taking your guitar skills to the highest level.
×