The top, back and ribs of an acoustic guitar body are very thin (1–2 mm), so a flexible piece of wood called lining is glued into the corners where the rib meets the top and back. This interior reinforcement provides 5 to 20 mm of solid gluing area for these corner joints. Solid linings are often used in classical guitars, while kerfed lining is most often found in steel string acoustics. Kerfed lining is also called kerfing because it is scored, or "kerfed"(incompletely sawn through), to allow it to bend with the shape of the rib). During final construction, a small section of the outside corners is carved or routed out and filled with binding material on the outside corners and decorative strips of material next to the binding, which are called purfling. This binding serves to seal off the end grain of the top and back. Purfling can also appear on the back of an acoustic guitar, marking the edge joints of the two or three sections of the back. Binding and purfling materials are generally made of either wood or plastic.
In acoustic guitars, string vibration is transmitted through the bridge and saddle to the body via sound board. The sound board is typically made of tone woods such as spruce or cedar. Timbers for tone woods are chosen for both strength and ability to transfer mechanical energy from the strings to the air within the guitar body. Sound is further shaped by the characteristics of the guitar body's resonant cavity. In expensive instruments, the entire body is made of wood. In inexpensive instruments, the back may be made of plastic.
You need to place one finger on whatever fret you want to bar and hold it there over all of the strings on that fret. The rest of your fingers will act as the next finger down the line (second finger barring, so third finger will be your main finger, and so on). You can also buy a capo, so that you don't have to deal with the pain of the guitar's strings going against your fingers. The capo bars the frets for you. This also works with a ukulele.
Unlike many string instruments which use a bow to create a sound, guitars are played by plucking or strumming the strings on the instrument, which vibrate to create a sound. Chords are played when the guitarist holds their fingers down on more than one individual string to change its length, which in turn changes the frequency of the vibration created - in other words, it creates a different note. Performers often use guitar tabs, rather than sheet music, when learning music: this acts as a kind of 'map' to teach guitarists where to put their fingers on the strings.
×